ENGLISH
1
Hook C-Clamp to inner stopper
PS2
AA Size Alkaline Battery
SWITCH
PC/PS3
USB Port
RX LED Link Power LED
System Requirements:
For PC
IBM PC Pentium 166MHz compatibles or higher.
Microsoft Windows VISTA/XP/ME/2000/98
CD/DVD-ROM Drive for driver installation.
For PlayStation
PlayStation
2
PlayStation
3
Software Installation:
Install the driver first before you install
Wireless Trio Racer
to the system. The Wheel will not support
the vibration function, if the driver is not installed.
1. Insert the driver CD into your CD-ROM; wait for a few seconds for your PC to load the disc; the auto run program is
executed and the opening installation screen appears. Please follow the on-screen instructions.
2. If your system doesn’t launch the installation software automatically, you can locate the file in the directory of your CD drive
and click on it, then follow the on-screen instruction to install the software.
Hardware Installation
1. Connect the USB Cable and plug it to an USB port on the PC/PlayStation
3 or a USB Hub. Then, connect the Pedals to the
main unit with the included cable. After connection, system will “Find a new hardware” and complete the installation.
2. Go to Game Controllers page and select “Advanced“. It should work as a wheel. Or a game pad with compatible electrical
function design. Check the installation again if it is not correct.
Set wireless function:
Once you complete the
Wireless Trio Racer
installation, it will automatically search and link with the receiver. The green LED
on the steering wheel will be lit for five seconds then will turn off if you have a successful connection.
Link Mode
Wake suspend mode up
Suspend Mode
Low Battery Indicator
START/Key 10+Key11/Fn button at Wheel
Connect button at Receiver Dongle
START/Key 10 button or
SELECT/Key 9 button.
After 2 minutes without
any button activity.
Green LED continues to
flash slowly.
Turbo Function:
1. Set/Clear Turbo Function: Press and hold the TURBO button, then press any action Key except buttons 9-10, or Brake
Pedal to set the turbo function for it. Turbo LED will flash accordingly. To release the Turbo function, repeat the same
procedures.
2. Set Turbo Speed: Press and hold the Turbo button, then press the Key_10/START button only. The Turbo speed will be
adjusted cyclically from 2->4->8->16->2 Hz, each time the Key_10/START button is pressed.
Turbo Speed Setting Key Remapping Setting
PS3 Mode
Select_Key
Start_Key
PS_Key
Turbo+ Key10/Start
Key_10/START + Turbo
Switch to PS Position Key_9
Key_10
Key_Fn at PS mode
Active Direction Function for Game Setup Page:
1.
Press Key9-Select button for two seconds, the Turbo LED will light to show the activation of “Direction function”.
The following will act as each direction controlling: Button 5=
UP
; Button 6 =
DOWN
; Wheel Turn to right =
RIGHT
; Wheel
Turn to left
= LEFT.
2.
Press Key9-Select two seconds again to release the Direction function. The Turbo LED will return to normal status.
Wireless Trio Racer
Brake
Acceleration
Key1
Key3
Key10/Start
Key8
Power Switch
Key7
Key4
Key2
Key5
Key9/Select
Turbo
Led
Pedal Connector
Turbo Key
Key6
Key11/Fn
DC 5V
