Copyright 2012, GenTent® Safety Canopies, LLC. All rights reserved. Nottingham, NH, USA. www.gentent.com
Email: support@gentent.com
Telephone: 781-33G-TENT (774-334-8368)
THANK YOU
The GenTent Ridgid Frame Extender Kit
includes everything you need to allow the
GenTent to mount to your Ridgid RD Series
generator
GenTent
®
Ridgid RD Kit
Installation/Safety Manual
WHAT YOU WILL NEED
- Electrical drill
- 5/32” Drill bit
- 5/16” socket or open end wrenches
- Phillips head screwdriver
- This guide
INSTALLATION OVERVIEW
The process should take about 15 minutes:
Remove rear bumpers:
Remove screws
holding bumpers and remove bumpers
Install Frame Extenders:
Connect bottom
through foot bolt or screw direct to frame.
Connect top through slot at top of frame.
Install GenTent Tips:
Use Long skirt for
installation; position GenTent door
opposite muffler side; handles should be in
the down position when using GenTent
Once these steps are taken, follow GenTent
installation guide.
IMPORTANT PRODUCT SAFETY
WARNING
Always shut generator off before performing the steps in this installation guide.
WARNING
Allow generator to cool prior to performing the steps in this installation guide.
WARNING
Never
block or cover the generator exhaust muffler in any way. GenTent canopy must be
installed above generator exhaust muffler. Install GenTent electrical skirts such that they
cannot
block exhaust in any way.
PACKAGE CONTENTS
1 – Installation and Safety Manual
2 - 22” Ridgid Frame Extenders
4 - #12 Sheet metal screws
