38
MAN0340001 - 07/2019
www.gentilinair.com
Instruction Manual - Clinic 3.40 Compressors
RESEttabLE tHERmaL
If there is an overload and/or a short circuit in the electrical system of the
machine, the overload protection intervenes stopping the electric motor.
The reset will occur automatically when the temperature returns within the para-
meters preset by the manufacturer:
1) Set the switch (18) in pos. “OFF (0)”.
2) Press the button of the resettable thermal (7).
3) Before restarting the machine wait a few minutes.
IF AFTER PERFORMING THE RESET THE MACHINE WILL NOT RESTART, THE
opERatoR IS REQuIRED to obtaIN tHE INtERVENtIoN of maINtENaNCE
tECHNICIaNS aND/oR tHE autHoRIZED DEaLER.
tuRNINg off tHE maCHINE
At the end of the work cycle perform the turning off of the machine as fol-
lows:
1) Set the switch (18) in pos. “OFF (0)”.
2) Unplug the power cord (15) from the socket and place it next to the machine.
3) Only in case of work cycle end perform the condensate discharge from the
tank, acting on the condensate drain valve (12).
EmERgENCY Stop
The Emergency Stop of the machine can be done by bringing in pos. “OFF
(0)” the switch (18). To avoid situations of imminent danger, the Authorized
Operators are obliged to perform the following operations:
1
RUN IMMEDIATELY THE TURNING OFF OF THE MACHINE AS DESCRIBED IN PAR.
“TURNING OFF THE MACHINE”.
2
REPORT IMMEDIATELY THE EMERGENCY TO THE SUPERVISOR IN CHARGE.