Confirm the orientation of the front rail. When the rig is viewed from
the front there should be a vertical hole immediately to the left of the
each of the holes that the top rods are inserted into. Refer to the picture
above and the picture in step 4 if you are unsure.
The rods should be flush with the front of the square front rail. Secure
by tightening (clockwise) the two allen (hex) head bolts recessed into
the underside of the rail. Do not over tighten, use a short allen key and
hand pressure only. Check the square rail assembly is firmly attached to
the horizontal rails before proceeding to the next step.
Gently tighten the 6 gold locking tabs on the top camera assembly
before proceeding to step 4.
