III.
Operation
Insert the AAA battery, checking the correct polarity (+/-).
1.
Power On/Off
1.1
Pager On
Press “Read/confirm” key for two seconds, the screen will display all characters/symbols
and the pager will alert briefly. The pager is now ready in standby mode.
1.2
Pager Off
Press “Selection” key until “PGR OFF” appears on the screen, now press “Read/Confirm.
No message is received when the pager is off, but the date and time are still retained.
Note: the “Pager Off” feature may have been disabled on your pager. If in doubt,
check with your dealer.
2.
Messages
2.1
Receiving Messages
The pager will sound or vibrate to alert the user when it receives a message (the
alternative of sound or vibration depends on the setting of the Alert Mode), and the latest
message will be displayed on the LCD as:
If the user doesn’t read the message within eight seconds, the number of unread messages
will be shown on the screen as:
2.2
Reading Messages
Press the “Read/Confirm” key when the current display is in standby (when date/time is
normally displayed), then the number of messages will be displayed:
Continue pressing the “Read/confirm” key, the messages are displayed one by one; if
there are unread messages, the latest unread message will be shown. Press the
“Read/confirm” key continually to read the messages from the latest to the earliest. Each
entry can have a maximum of four screens’ display. The first screen is for the message
number and content as below:
