38
G.3 Communications
To add a communication port based off the Geokon Cell Modem Template, press the “Add
Root” button and select a device. Continue selecting devices from the Add Box as shown until
the communication link to the Datalogger is represented. Once the Datalogger (CR6Series) is
added to the Network Map, press “Apply”. Select “IPPort” (Figure 38) and then Select
“PakBusPort (PakBus Loggers)” (Figure 39)
Figure 38 - Add Communications Port (Root)
Figure 39 - Select “PakBusPort”
Select “CR6Series”. When finished, press the “Apply” button at the bottom left of the Setup
Screen.
Figure 40 - Select Device to Add
