45
Sensor Model:
The sensor model is selected from the list of supported sensor models,
i.e., “45xx”. When the selected sensor model is “49xx” another parameter is displayed to
allow the number of sensors per gage can be entered (see Figure 72 below). This
parameter is used to detect missing gages in a multi-gage load cell.
Figure 72 - Sensor Model 49xx Selected
4.2.2 Sensor Settings Page Two, Conversion Method and Coefficients
The second page of the Sensor Setting window contains parameters that determine how
sensors are converted from Digits to Engineering Units. The upper portion of the screen
contains radio buttons to select either the Linear or Polynomial conversion method
(Figure 73). Each conversion method and the corresponding coefficient options are
described in the subsections below.
Figure 73 - Conversion Method Radio Buttons
