64
5)
Insert the two D cells straight down into the battery holder. Ensure that the polarity of the
batteries matches the diagram on the battery holder.
Figure 29 - Batteries and Cable Installed
6)
After installing the batteries and wiring the cable into the terminal block (Figure 29), gently
close the lid making sure no cables are pinched.
7)
Line up the holes in the lid with the holes in the body. Install and tighten the screws in a
zigzag pattern, ensuring that the cover seals tightly and evenly.
8)
Screw the Swagelok nut loosely onto the bulkhead.
9)
Gently feed the cable into the logger until the mark made previously is just above the top of
the Swagelok nut. Tighten the Swagelok nut until it is finger tight.
10)
Make a mark on the Swagelok nut as well as directly below the nut on the bulkhead (Figure
30).
Figure 30 - Marks on the Swagelok Nut and Bulkhead
