21
20
•
Display :
- Top line : Time
- Middle line : Day, week and date
- Bottom line : Year
•
The screen will display the word TIME at the lower left of the screen.
The symbol for the daily alarm will appear if the function is selected (see corresponding
chapter).The sound that signals activation of the buttons is also present in the lower left
of the screen if activated (press
START/STOP
to activate or deactivate).
•
A brief display on the middle line (Time) indicates that you have entered this mode.
•
START/STOP : loud beep when entering the setting mode
•
On the top line, you will read the time in Anglo-Saxon mode (0-12 hours AM/PM) or in
European mode (0-24 hours). Going from one to the other is done by pressing the
SPLIT/RESET
button.
On the middle line, you will read the date in the format day week-day of the month-month
or week-month-day of the month respectively, depending on whether the European mode
(EU)
or Anglo-Saxon mode
(US)
has been activated (see settings chapter)
The current year will appear on the lower line. The day of the week is automatically
calculated based on the year and the date.
•
Setting the time and date.
Press for a longer time (2s) on the
RECALL
button. The word
SET
and the number of
seconds will flash to indicate that you have entered the setting mode.
•
Press the
SPLIT/RESET
button repeatedly to change the parameter to set, following
sequence …seconds-hour-minutes-year-month-day-display in European or Anglo-Saxon
mode (date in the format DD/MM or MM//YY)…
When the elements flash, press the
START/STOP
button to reset the seconds to 0 or
scroll through the numbers of the parameter to the desired value. Hold the button down to
set more rapidly.
Press
RECALL
again to leave the setting mode.
2 Daily Alarm Mode
START/STOP :
activate/deactivate the alarm
RECALL :
to enter the setting mode
SPLIT/RESET :
inactive
MODE :
go to the following mode
•
Display :
- Top line : Time
- Middle line : Alarm
- Bottom line : Wake-up time
•
The symbol for the daily alarm will appear if the function is selected (see corresponding
chapter).
The word
ALARM
will appear for several seconds once you have arrived in this mode, and
then remain displayed on the middle line.
•
On the top line, you will read the time displayed according to the setting made in the
preceding chapter, in 12h or 24h mode.
On the bottom line, you will read the alarm time in the same format as that of the time, set
in the time date mode.
•
Press the
START/STOP
button to alternate between activating and deactivating the
alarm.
•
Set the alarm
Press longer (2s) on the
RECALL
button. The word
SET
and the number for the alarm
hours will flash to indicate that you have entered the setting mode.
•
Press the
SPLIT/RESET
button repeatedly to change the parameter to set following the
sequence …hour-minutes-…
When one of the elements flashes, press the
START/STOP
button to make the numbers
scroll until you reach the desired value. Press
RECALL
again to leave the setting mode.
•
When the alarm goes off, it sounds for 20 seconds.
Press on any button to stop the sounding.
ALARM
’’
00
PM
:
02’:00’’
00
AM
:0
7’:06’’
39
Summary of Contents for WATCH CHRONO 700
Page 1: ......
