15
EM61MK2 Data Logging System (DAS70/61MK2)
9. Set P
9. Set P
9. Set P
9. Set P
9. Set Port for GPS Menu
ort for GPS Menu
ort for GPS Menu
ort for GPS Menu
ort for GPS Menu
After the Set Port for GPS option is selected in the Main Menu the Set Port for GPS menu appears
on the screen. This menu allows you to enable and disable the GPS input, specify serial
communication parameters matching GPS receiver settings, and to monitor the GPS output in
terminal mode (key F3). The menu is presented below.
GPS Input
This option allows you to Enable/Disable a serial port for GPS input. When Disabled is
chosen logging and monitoring screens will display message “GPS disabled” in place of
GPS parameters.
The GPS Input can be Enabled even if there is no GPS system connected to the Allegro.
In such case data file will contain proper sequence of EM61-MK2 readings without any
GPS input.
COM Port
The number of serial port that is assigned to the GPS input. Available selections: COM1
and COM 2. The program default is COM2. Communication parameters for the selected
serial port can be determined in options described below.
This port must be different than the port specified in the Logger Set Up menu (for EM61-
MK2), otherwise a message will be displayed and ports will have to be reassigned.
Baud Rate
Specify Baud Rate for the output port, the selected value should much the Baud Rate of
the GPS system, default is 9600.
Parity
Select Parity for the output port, the entered parameter should much the Parity set in the
GPS serial port settings, default is N.
Data Bits
Specify Data Bits for the output port, the entered value should much settings in the GPS
system, default is 8.
Stop Bits
Specify Stop Bits for the output port, the entered value should much settings in the GPS
system, default is 1.
Summary of Contents for EM61MK2A
Page 2: ......
