24
Geonics Limited
Wheel Inc.
When this option is highlighted press
Left
or
Right
arrow key to activate editor and then
enter desired value.
Wheel increment is approximately 20 cm (or 0.64 feet) for the EM61-MK2 equipped with
1 x 0.5 m, 1 x 1 m, and 0.5 x 0.5 m antennas. The Hand Held EM61-MK2 has two wheel
increments 0.1 and 0.2 m. Check the wheel increment setting on the antenna assembly.
This option is available only when the Wheel mode was selected.
Use
Down
or
Up
arrow key to leave editor.
Readings/s
When this option is highlighted press
Left
or
Right
arrow key to activate editor and then
enter desired value.
This parameter describes number of readings per second that will be taken. Any number
larger than zero can be entered, however the EM61-MK2 maximum frequency of data
output is 16 readings per second.
At high frequencies (above 10 readings per second) obtained frequency may differ from
the specified rate, however speed of data collection will be consistent for a given field
computer. The real speed of data collection (in Auto mode) depends on the field computer
used and display type. In general, displaying data in the text mode allows for faster data
collection and while using fast computers the difference between specified and obtained
frequency is very small.
This parameter is available only when the Auto Mode was selected.
Use
Down
or
Up
arrow key to leave editor.
Surv Line
(survey line name)
When this option is highlighted press
Left
or
Right
arrow key to activate editor and then
enter desired value. Use
Down
or
Up
arrow key to leave editor.
This is a user’s tag number/name for the profile line. The length of the name can not
exceed 8 characters. The line name is usually used as a coordinate perpendicular to the
survey lines direction. For example, when survey lines are laid out along W-E direction
stations describe W-E coordinate, while Line names may describe S-N (vertical on a map)
coordinate.
Line Incr.
(survey line name)
When this option is highlighted press
Left
or
Right
arrow key to activate editor and then
enter desired value.
This parameter specifies the distance by which survey lines will be separated. This setting
Summary of Contents for EM61MK2A
Page 2: ......
