6
ELECTRIC CONVERSION
Then, loosely install the two M5
×
15mm flat head screws (item #22) into the passenger frame
plate. Finally, tighten all the screws on the passenger frame plate first, and then tighten the
screws for the roll cage.
m. Install the driver frame plate (item #11) to the box frame plate (item #12) and the roll cage
using three M5
×
15mm flat head screws.
n. Follow electric conversion video #5 to set up the mesh. Do
not
apply green Loctite to the motor
shaft. Only apply low-temperature Loctite to the pinion gear’s set screw.
For the RB kit, install the pinion gear with the set screw facing inward toward the motor, as
shown below.
o. Do not reinstall the side rail guards, wheels, or the battery box with servo.
16
Summary of Contents for AutoRally
