13
FRONT BRAKES, DISC ALIGNER
i.
Only complete this step if you are installing front wheel rotation sensor magnet
mounts and not using front brakes.
Use hot glue to secure one of the sensor assemblies
to each of the front hubs.
Carefully align the sensor with the magnets on the front
rotation sensor magnet mount/brake disc
in order to ensure that the sensor will reliably
detect each magnet as it passes the sensor face.
Note that only 4 sensor assemblies are required for the chassis; 2 of the 6 assemblies
are spares.
13 Front Brakes, Disc Aligner
Time
3 hours 0 minutes
Parts
•
Mecatech front brake kit
•
Brake bleeding kit
•
3D printed master cylinder mount
•
2 3D printed front brake disc aligners
•
Fabricated master cylinder plate
•
12 1/8” diameter magnets
•
3 M3
×
10mm screws
•
3 M3
×
12mm screws
28
Summary of Contents for AutoRally
