13
FRONT BRAKES, DISC ALIGNER
d. Verify that the magents are aligned with the sensors hot glued to the hub and that the magenets
clear the calipers when spinning. Adjust the sensor locations if required.
e. Attach the master cylinder to the aluminum master cylinder plate using 2 M4
×
6mm screws and,
if necessary, use M4 washers to keep the screws from bottoming out. (The Mecatech instruction
says to use the pedestal, but do not use the pedestal.) Slide brake rod through the last hole in
the the master cylinder arm with the rod on the side of the arm away from the bracket.
f. Remove the 3 M3 button head screws from the top of the conversion kit top plate on the left
side of the chassis (opposite side as the tranmission).
g. Attach the 3D printed servo mount and master cylindar plate onto the chassis using 3 M3
×
12mm
screws, make sure to use low temp (red or blue) threadlock.
h. Attatch the servo to the 3D printed servo mount with the servo gear facing the back of the
chassis using 4 M4
×
14 screws and M4 nuts.
i. Install the pivot linkage as shown in the picture in the next step to attatch the brake rod to the
F 25 servo horn through the outtermost mounting hole. You may have to use a longer M3 screw
than comes with the pivot kit to attach the pivot to the servo horn.
j. Attach the F 25 servo horn to the servo in a position that is parallel to the master cylindar arm.
Make sure the servo is in neutral position before attaching the servo horn (you can do this by
powering the servo and sending it a neutral signal).
30
Summary of Contents for AutoRally
