13
FRONT BRAKES, DISC ALIGNER
k. Make a 10 inch servo extension cable with the Futaba J connector assembly.
l. Follow the normal instructions for connecting brake lines and bleeding. The brake lines should
not be rubbing against the tires or any moving component of the vehicle, but the lines should
still have enough slack to allow the wheel to steer from side to side. Refer to the pictures below
for the correct routing of the tubing. Make sure to measure and cut the tubing to the exact
desired length before putting it into the valve. Instructions on bleeding the brake can be found
at
. The bleeding process should be repeated multiple times from
each opening to ensure the elimination of all air bubbles within the tubing. Close all the valves
tightly to ensure that air bubbles do not form.
31
Summary of Contents for AutoRally
