14
TIRE FOAMS
m. Secure the brake line with a few zip ties to the chassis so they do not snag on chassis parts when
the steering actuates and install a bleed valve cap on the brake caliper and master cylindar bleed
valves once done bleeding.
n. Cut the brake rod so that it doesn’t extend beyond the linkage. You will also have to cut a little
of the motor shroud to allow the linkage to freely actuate once the shroud is reinstalled.
14 Tire Foams
Time
2 hours 0 minutes
Parts
•
Zero-growth tire foams front (red)
•
Zero-growth tire foams back (blue)
Instructions
a. Refer to the Baja 5SC manual for tire foam replacement diagrams
b. Remove all of the bolts on both sides of the tire. Remove the beadlocks and slide off the rubber
tire and remove the inner foams.
c. Slide the new front tire foams onto the front tire rims. Front foams are 1cm narrower than the
rear.
d. Slide the new rear tire foams onto the rear tire rims.
Rear foams are 1cm wider than the
front.
e. Slip the tire rubber over the foams and begin to screw in the bolts in an alternating pattern.
Refer to the HPI Baja 5SC manual for example diagrams. It may be difficult to align the bolts
and holes for the rear tires.
32
Summary of Contents for AutoRally
