25
WIRE MANAGEMENT
d. Attach zip ties on each end of the split loom to hold the wires in place.
e. Zip tie the split loom to the chassis near the electronics box using the hole that exists in the
chassis, the engine mount brace above the side rail guards, and the hole in the back plate under
the ESC.
f. Zip tie antenna to the split loom and the USB cable harness to the engine mount brace as shown
in the picture. This point acts as a pivot for movement of the USB cable which will be plugged
into the compute box.
63
Summary of Contents for AutoRally
