25
WIRE MANAGEMENT
g. Hot glue Futaba J male housing of the wheel rotation sensor wires to the shock towers of the
chassis.
h. Loop the front wheel rotation sensor wires around the front supports in order to reduce slack to
the minimum required to route these wires, if needed.
i. Zip tie front and rear wheel rotation sensor wires over the connector housings hot glued to the
shock tower.
j. Install the 4 small body clips into the plastic electronics box supports. Ensure that the USB
cable, split loom, and front wheel rotation sensor cables are routed through the appropriate
cutouts.
64
Summary of Contents for AutoRally
