4
LASER CUTTING
•
6mm thick Craft Foam
Notes
•
If available, use a laser cutter to cut out the parts. Otherwise, print the provided PDFs onto
paper and use as stencils to cut the part manually.
Instructions
a. GPS box lid
i. Using the provided
GPS Box Lid.pdf
file, cut out the electronics box lid.
ii. Roughly cut the copper sheet to the shape of the GPS box lid. Apply the adhesive side of
the copper sheet to the top surface. Refer to either image below as reference for the top
surface, which is the surface the antenna will be mounted against.
iii. Trim the excess copper around the edges and through the holes of the GPS box lid.
5
Summary of Contents for AutoRally
