8
BATTERY BOX ELIMINATOR AND STEERING SERVO
b. Mount the side rail guards, and add a drop of threadlock on each of the four mounting screws.
If available, use the Integy side rail guards instead of the stock plastic side rail guards.
8 Battery Box Eliminator and Steering Servo
Time
1 hours 0 minutes
Parts
•
Team Fast Eddy Battery Box Eliminator Kit
•
Savox steering servo
•
2 small body pins
•
M3 lock nut (part no. Z663 in the Baja kit)
•
Alloy Horn for Multiplex RHINO Digi 4 Servo
Instructions
a. Secure steering servo to battery box eliminator with 4 included screws ensuring correct orienta-
tion.
i. To secure the steering servo into the battery box eliminator, remove the 4 screws on the
base of the servo and take-off the base. Then slide the servo into the eliminator bottom
first. Put the base back onto the servo and secure it with the 4 screws (Refer to images for
proper orientation of the servo with respect to the battery box eliminator). Finally, secure
the servo to the battery box eliminator using the 4 provided screws. Use thread lock as they
are metal-to-metal connections (Disregard the nuts, spacers, etc. provided with the servo
for now).
Ensure that the gasket is aligned and the servo base plate is seated
correctly.
19
Summary of Contents for AutoRally
