Be sure to charge the battery sufficiently prior to operation. Fill the barrel with prepared liquid through the screen and
close the barrel cover. Observe to check whether leakage occurs to the bottom of barrel or not. Turn on the power
switch and clench the switch handle to start spraying. Either instant or continuous spraying is allowed.
Three kinds of nozzles are supplied to cater for your demands
5.
Notes
6
The battery has been charged before being delivered. However, it will self-discharge in the course of
transportation and storage. Additional charging before initial use thus is required.
7
Try your best to avoid operating the sprayer without water in it which may damage the diaphragm.
Never place the sprayer upside down . Otherwise the battery may be damaged.
8
In case of bumming heard from inside the sprayer or poor atomization after long time use, it shows
low batter voltage and requires timely charging. Connect the plug of charge to “Charging ” jack without
removing the battery from the sprayer. For each charging, a duration of at least 8 hours is required. The
charger shall be put at a dry , well-ventilated, safe place over 50 cm high above the ground.
9
Trial spraying with clean water is necessary for initial use ,so as to make sure neither leakage nor poor
atomization occurs.
10
There are a few points the operator should remember when spraying:
*
Wearing of mask and gloves is required. Never operate when spraying: contact your body.
Never spray the pesticide against the wind, Never spray at human, animals or food. Never
operate for a long time under high temperature. Never drink alcohol immediately after
spraying. Strict compliance with safety instructions of pesticide manufacturer is required
while handling the pesticide.
*
Never operate with such special liquid as strong acid, strong base and flammable goods.
Never use high -persistent and very toxic pesticides for pest controlling purposes on
vegetables, fruit trees, tee and medical plants.
*
The unit shall be cleaned thoroughly after each use so as to avoid corrosion , clogging and
mixing of residual liquid with liquid of next spraying which may do harm to crops or reduce
the effects. Cleaning way: for exterior, scrub with a dampened cloth. For interior, fill with
small amount of water and shake before turning on the power to discharge.
6.
In case of short-term operations, charging is not required for each use. In case of long-term storage,
regular full discharging and recharging with an interval of half a month, a month or two month or are required
to ensure the service life of battery.
7.
Don ’ t operate this Sprayer at a place with a temperature exceeding 45'C or lower than -10°C.
8.
After use for half a year, you should dismantle the base and check whether the screws loose or not.
If loose, please tighten them.
*
Be sure to switch off the power before storage.
*
It’ s strictly prohibited to keep this Sprayer near fire or expose the base to water or immerse
the machine in the water for cleaning or filling of water.
*
Never spray powders or particles with this Sprayer.
*
Unauthorized removing of the charger’ s housing is prohibited.
Problems
Causes
Solutions
The motor fails to start after
being powered on.
1.
The power cables come off.
2.
The battery is out of power.
3.
The power switch has been damaged
1.
Dismantle the base to connect the cables
soundly.
2.
Charging.
3.
Replace the switch.
Abnormal sound heard In the
motor.
• The fastening screws of pump loose.
Tighten the screws.
Leakage occurs to the bottom of
base
• The inlet and outlet tubes of pump break or
loose at the joints.
• Dismantle the base and tighten the tube clamp;
Repair.
Poor atomization
1.
The spraying hole was clogged.
2.
Spraying hole and split sheet wore out.
3.
Spraying sheet inversely mounted
4.
Filter screen was clogged.
5.
Leakage occurred to tubes at joints.
6.
Batter short of power
7.
Air remained in the pump.
1.
Remove foreign matters,
2.
Replace the spraying sheet and split
sheet
3.
Correct
4.
Clean
5.
Tighten.
6.
The alarm out of order, replace it;
charge.
7.
Remove the nozzle or spraying rod to
discharge the air.
