Administrator Mode
103
4
To enable the Center V2 connection:
1.
Activate Link:
Enable the monitoring through Center V2.
2.
Host Name or IP Address:
Type the host name or IP address of Center V2.
3.
Port Number:
Match the port to
Port 2
on Center V2. Or keep the default value 5551.
For details, see
8.1 Center V2.
4.
User Name:
Type a valid user name to log into Center V2.
5.
Password:
Type a valid password to log into Center V2.
6. Click
Apply
. The
Connection Status should display “Connected” and the connected
time.
7. To establish the connection to the second Center V2, click the
Connection 2
tab and
repeat the above steps for setup.
These options can also be found on this Center V2 setting page:
Cease motion detection messages from:
Stops notifying Center V2 of motion-
triggered events.
Cease input trigger messages from:
Stops notifying Center V2 of input-triggered
events.
Enable schedule mode:
Starts the monitoring through Center V2 based on the
schedule you set in the
Select Schedule Time
section. Refer to
4.5 Recording
Schedule
for the same settings.
For related settings to activate the monitoring through Center V2, see
4.1.2 Motion
Detection
,
4.2.1 Input Settings
, and
8.1 Center V2.
Summary of Contents for FER521
Page 96: ...82 4 1 1 Video Settings Figure 4 2A ...
Page 97: ...Administrator Mode 83 4 Figure 4 2B ...
Page 152: ...138 Figure 4 38 2 ...
