Getting Started
43
2
Chapter 2 Getting Started
This section provides basic information to get the camera working on the network.
2.1 Installing on a Network
These instructions describe the basic connections to install the camera on the network.
1. Using a standard network cable, connect the camera to your network.
2. Connect power using one of the methods:
•
Using the supplied power adapter, connect to power. For details, see
1.7
Connecting the Data Cable
.
•
Use the Power over Ethernet (PoE) function. The power will be provided over the
network cable.
3. You can now access the Web interface of the camera.
•
If the camera is installed in a LAN without the DHCP server, the default IP address
192.168.0.10
will be applied. You also can assign a static IP address. See
2.1.2
Assigning an IP Address
.
•
If the camera is installed in a LAN with the DHCP server, use GV-IP Device Utility to
look up the camera’s dynamic IP address. See
2.1.1 Checking the Dynamic IP
Address
.
Note:
See “Power over Ethernet” in Specifications later in this manual before purchasing a
PoE adapter.
Summary of Contents for FER521
Page 96: ...82 4 1 1 Video Settings Figure 4 2A ...
Page 97: ...Administrator Mode 83 4 Figure 4 2B ...
Page 152: ...138 Figure 4 38 2 ...
