46
2.1.2 Assigning an IP Address
By default, GV-Fisheye Camera that are connected to LAN without a DHCP server, are
assigned with the static IP address
192.168.0.10
. Follow the steps below to assign a new IP
address to avoid IP conflict with other GeoVision devices.
Note:
1. The computer used to set the IP address must be under the same network with the
camera.
2. If your router supports the DHCP server, the camera will obtain a dynamic IP
address from the DHCP server each time it connects to the LAN, instead of using
192.168.0.10. The default setting for automatic IP assignment is not available for
GV-FE2301 / 4301 and GV-FER521 using firmware V1.06 or earlier.
1. Open your web browser, and type the default IP address
2. In both Login and Password fields, type the default value
admin
. Click
Apply
.
3. In the left menu, select
Network
and then
LAN
to begin the network settings.
Figure 2-4
4. Select
Static IP address
. Type IP Address, Subnet Mask, Router/Gateway, Primary DNS
and Secondary DNS
in the
Configure connection parameters
section.
5. Click
Apply
. The camera is now accessible by entering the assigned IP address on the
Web browser.
Summary of Contents for FER521
Page 96: ...82 4 1 1 Video Settings Figure 4 2A ...
Page 97: ...Administrator Mode 83 4 Figure 4 2B ...
Page 152: ...138 Figure 4 38 2 ...
