Administrator Mode
69
4
To enable the VSM connection:
1.
Activate Link:
Enable the monitoring through VSM.
2.
Host Name or IP Address:
Type the host name or IP address of VSM.
3.
Port Number:
Match the port to
Port 2
on VSM. Or keep the default value 5609. For
details, see
8.2 VSM.
4.
User Name:
Type a valid user name to log into VSM.
5.
Password:
Type a valid password to log into VSM.
6. Click
Apply
.
The Connection Status should display “Connected” and connected time.
7. To establish the connection to the second VSM, click the
Connection 2
tab and repeat
the above steps for setup.
These options you can also find on this VSM setting page:
Cease motion detection messages from:
Stops notifying VSM of motion-triggered
events.
Cease input trigger messages from:
Stops notifying VSM of input-triggered events.
Enable schedule mode:
Starts the monitoring through VSM based on the schedule
you set in the
Select Schedule Time
section. Refer to
4.5 Recording Schedule
for the
same settings.
For related settings to activate the monitoring through VSM, see
4.1.2 Motion Detection
,
4.2.1 Input Settings,
and
8.2 VSM
.
