Administrator Mode
4
To enable the VSM connection:
1.
Activate Link:
Enable the monitoring through VSM.
2.
Host Name or IP Address:
Type the host name or IP address of VSM.
3.
Port Number:
Match the port to
Port 2
on VSM or keep the default value
5609
. For
details, see
7.2 VSM.
4.
User Name:
Type a valid user name to log into VSM.
5.
Password:
Type a valid password to log into VSM.
6. Click
Apply.
The Connection Status should display “Connected” and connected time.
7. To establish connection to the second VSM, click the
Connection 2
tab and repeat the
above steps for setup.
These options you can also find on this VSM setting page:
Cease motion detection messages from:
Stops notifying VSM of motion detection.
Enable schedule mode:
Starts the monitoring through VSM based on the schedule you
set in the
Select Schedule Time
section. For schedule setup, refer to
4.2.3 Center V2
.
73
