GeoVision GV-ML600 User Manual Download

Page: 2 / 7

Installation

Before installing, add the thread lockers to all screws. Firmly tighten the screws to avoid

fastening loosen.

1. Install the electromagnetic lock to the doorframe.

Note:

If the power switch is not wired between the DC source voltage and the magnet, it

will take longer to de-energize the magnet simulating residual magnetism.

Switch or

solid state

switching

device

Switch or

solid state

switching

device

Correct

Incorrect

June 3, 2015

Summary of Contents for GV-ML600

Page 2: ... 1 Install the electromagnetic lock to the doorframe Note If the power switch is not wired between the DC source voltage and the magnet it will take longer to de energize the magnet simulating residual magnetism Switch or solid state switching device Switch or solid state switching device Correct Incorrect June 3 2015 2 ...

Page 3: ...door Typical Installation of the electromagnetic lock Note To make the armature plate adjust its proper position to the magnet automatically do not fix the armature plate too tightly and make the rubber washer more flexible June 3 2015 3 ...

Page 4: ...er source 2 Power Switch Jumper Plug the power jumpers to Pins 1 2 and Pins 3 4 for a 12V DC power source Plug the power jumper to Pins 2 3 for a 24V DC power source 3 Sensor Connects to the access control system by using the black and red wires For details see Connecting to the GV AS Controller later in this installation guide June 3 2015 4 ...

Page 6: ...ensor to the GV AS410 connect the Red wire of the sensor to the Input of the GV AS410 and connect the Black wire of the sensor to the Ground of the GV AS410 2 On the Web interface of the GV AS410 select Input Configuration under Advanced Setting and select an input type and input function for the connected sensor from the electromagnetic lock June 3 2015 6 ...