PTZ Control Panel
131
5
5.13 System Configuration
Figure 5-13
Freeze:
Skip showing camera images while traveling from one preset to another. This
function is disabled by default.
Mechanic Flip:
This function is not supported.
Start-Up Action:
Defines the dome view movement when the camera reboots.
PTZ Idle Protection:
When the dome idles for a period of time, the user can select a
movement mode to activate automatic monitoring of the surveillance site. After the idle
time, the selected movement mode will be automatically activated. To configure and
enable this function, follow these steps:
1. Select
Idle Protection
to start setting.
2. Use the
Idle Time (Minute)
drop-down list to select the time length allowed for the
dome to remain stationary. The time length can be set from 0 to 120 minutes.
3. Use the drop-down list to select the desired movement mode. The modes include:
Preset:
When the Delay Time is up, the dome will automatically move to the
chosen Preset point. To configure a Preset, see
5.1 Preset Settings
.
Sequence:
When the Delay Time is up, the dome will automatically perform the
selected Sequence number. To configure a Sequence, see
5.4 PTZ
Settings-Sequence Settings
.
