GV-RK1352 / R1352 / DFR1352
25
2
2.6 Changing the Default Settings of Beeper and LED
You can change the default settings of the LED and the beeper by enabling a GV-AS210 /
2110 / 2120 / 410 / 4110 / 810 / 8110 to externally control the LED and Beeper. Through the
Web interface of the controller, you can set the controller to trigger the red LED, green LED
or beeper when the specified alert event occurs.
1. Enable external control of the reader’s Beeper and LED by using
GV-R/RK/DFR Config
AP
.
2. Wire the Beeper, Red LED and Green LED from the reader to GV-AS Controller.
3. Specify the Beeper and LED settings for each door through the Web interface of GV-AS
Controller.
Note:
GV-AS1620 can also externally control the reader’s LED and Beeper for access
granted and denied. For details, see
GV-AS1620 User’s Manual
.
2.6.1 Setting up Beeper and LED on GV-R/RK/DFR Config AP
To enable the external controls of the Beeper and LED on GV-R/RK/DFR Config AP, the
reader needs to be connected to a computer through GV-COM, GV-Hub or GV-NET/IO Card
V3.1.
1. Start
GV-R/RK/DFR Config AP
and select the COM port that is connected to the reader.
Note:
To see how to install the Config AP and how to identify the COM port of the reader,
see
2.4 Installing GV-R/RK/DFR Config AP
and
2.5.1 Defining the ID Number and Setting
the Reader to Slave
earlier in this installation guide