Mark2 Manuals
Mark2
- 12 -
6
、
How to unlock
Note: when the test motor turns, the propeller must be unloaded
-
Unlock type
The throttle to the minimum
Knock down 5 channels to unlock
7
、
Set up the VTX
1.
Set the Channel. In standby mode, press and hold the key for 3 seconds, the blue LED flashes, short press,
change the channel value.Every time 1 press will change the CH, followed by 1CH to 8CH cycles.
2.
Set the Band. In the channel setting mode, press and hold the key for 3 seconds, the green LED flashes, briefly
presses, changes the frequency group value.Every time 1 press will change the band, and then the A band to F
band loop.
3.
Set the Power.In the band setting mode, press and hold the key for 3 seconds, the red LED flashes, short press,
change the output power value.Every time 1 press will change the power, followed by 25mW / 100mW / 600mW
cycle.
4.
frequency table
：
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
Band A
5865
5845
5825
5805
5785
5765
5745
5725
Band B
5733
5752
5771
5790
5809
5828
5847
5866
Band E
5705
5685
5665
5645
5885
5905
5925
5945
Band F
5740
5760
5780
5800
5820
5840
5860
5880
Band R
5658
5695
5732
5769
5806
5843
5880
5917
Band H
5362
5399
5436
5473
5510
5547
5584
5621
