Mark2 Manuals
Mark2
- 7 -
2
、
Install Betaflight
-
Betaflight is an open source flight control procedures, specific introduction can refer to website:
https://github.com/betaflight
-
for the firmware required by Elegant, please click the following link to download the firmware
name:
betaflight_3.2.5_OMNIBUSF4SD.hex
Latest version of firmware download website:
https://github.com/betaflight/betaflight/releases
Be sure to download the
betaflight_3.2.5_OMNIBUSF4SD.hex
version.
-
Install driver and ground station Betaflight
https://github.com/betaflight/betaflight/wiki/Installing-Betaflight
Ground station Betaflight - Configurator download address (you need to install Chrome browser) :
https://chrome.google.com/webstore/detail/betaflight-configurator/kdaghagfopacdngbohiknlhcocjccjao/re
views
3
、
Install the Receiver
-
If you choose the BNF version, you can Bind use the frequency and do not need to install the receiver again.
-
if you choose the PNP version, you will need to install the receiver on your own, Please click the following steps to
connect (such as the Frsky r-xsr receiver) :
note:must dismantle propeller for debugging.
Open the screws of the Elegant, open the top vtx board, and you can see the flight control board on the second
floor.
The flight control board will have three welding locations: 5V,GND,S.Bus, Welding in the corresponding position
Finally, fix the receiver and lock the corresponding screw
As shown in the picture below:
