Ladybird I Folder
March 2014
Intro
Service Manual
V
REFERENCE SYMBOLOGY
Note, adjustments, and parts list, support the checklists and the RAP information. The
symbols that refer to this supportive data are shown below
Note
1
This symbol is used to refer to notes usually found on the same page.
Adjustment
This symbol refers to an adjustment procedure located in Section 4 of this
Service Documentation. The number adjacent to the symbol indicates the
number that is assigned to that adjustment
Voltage Source
This is an indication of the source voltage that is used for operation of a
component.
Status Code
C1.01
A box in the control logic section of the circuit diagram represents the
status code.
Flag
2
This symbol indicates an area of a Circuit Diagram that you should check.
Component Control
[0403]
The code [0403] is an example of an output diagnostic test.
Switches and Relay Contacts
Safety interlock switch that is open
Safety interlock switch that is closed.
Switch/relay contacts with momentary contacts shown normally open.
Switch/relay contacts with momentary contacts shown normally closed.
Connectors numbering
This symbol indicates the numbering of the connector pins
Parts List
PL 1. 1
Reference to an Exploded Drawing - The spared component is found in the
particular drawing in the Parts List.
WARNING
This WARNING alerts users to areas of the product where there is the
possibility get an electric shock
WARNING
This WARNING alerts users to areas of the product where there is the
possibility of personal injury
CAUTION
!
This CAUTION alerts user that a wrong operation could damage the Folder
NOTE
This symbol alerts user to pay attention in the operation described
CAUTION
ESD
This symbol Is used when components In the copier are susceptible to
damage from electrostatic discharge. Observe ESD procedures to avoid
component damage.
The Signal Flow
This symbol indicates an interrupted signal in a horizontal direction.
Ground
This symbol indicates a machine ground.
Connector
5
JXX
Plug I Jack Connector and pin number
Motor
Motor
Thermistor
Thermistor Bead, used to sense temperature
