EGE-MSI-848
8 x 8 M o d u l a r i z e d E n c l o s u r e
( 4 8 2 m m × 3 8 0 m m × 1 0 0 m m )
5
6.2 Rear Panel
100-240VAC
50/60 Hz
OUTPUT
MODULE
INPUT
MODULE
RS232
CONTROL
IR ALL
OUT
IN
SERVICE
OUTPUT 0
IR IN
2
1
3
4 5
Note: The above panel is an example of 8×8 HDMI configuration.
1
OUTPUTS 1~8:
Install an Output module as required for connection to up to 8 displays
(TV or monitor) or CAT5e/6/7 outputs or compatible HDBaseT receivers (dependent on
module configuration).
2
CPU (Control Board)
IR IN: For IR control of the matrix only. Connect to the IR Extender for IR signal
reception of the IR remote control of the matrix. Ensure that the remote being used is
within the direct line-of-sight of the IR Extender.
RS-232: Connect to a PC/Laptop with a D-sub 9-pin cable for RS-232 command
sending and controlling over the Matrix.
CONTROL: Connect to an active network for LAN serving and Telnet/WebGUI control.
LAN serving on compatible HDBaseT input/output modules and transmitters/receivers
only.
ALL IR OUT: Connect the IR output to the IR Blaster for IR signal transmission of the
equipment to be controlled. Place the IR Blaster in direct line-of-sight of the equipment
to be controlled.
ALL IR IN: Connect the IR input to the IR Extender for IR signal reception of the IR
remote control of the equipment to be controlled. Ensure that remote being used is
within the direct line-of-sight of the IR Extender.
Note: For IR control of the HDBaseT input/output modules and transmitters/receivers
only. IR signals received by all IR Extenders connected to the transmitters/receivers will
be transmitted by all IR Blasters connected to the transmitters/receivers.
SERVICE: Firmware update only.
3
INPUT 1~8:
Install an Input module as required for up to 8 source devices or CAT5e/6/7
inputs for compatible HDBaseT transmitters (dependent on module configuration).
4
POWER SUPPLY:
The matrix will automatically turn on when connected to an active
power supply.
5
VENTILATION FAN:
This fan will automatically operate when the matrix is switched on.
Do not block the exhaust of the fan or cover it with any object. Please allow adequate
space around the unit for air to circulate freely.
