AccuPlot and AccuJet Maintenance
5-4
Loading Plotter Paper
To Load A New AJ-520 Supply Roll
Loading paper requires that you load the new supply roll, load the new take-
up roll, and feed the paper through the paper path.
WARNING: F
AILURE TO DISABLE SERVO POWER BEFORE PUTTING YOUR HANDS IN
OR NEAR THE PLOTTING AREA CAN RESULT IN INJURY
.
T
O LOAD A NEW PAPER SUPPLY ROLL ON THE
A
CCU
J
ET
AJ-520
1. Verify that the servos are disabled.
2. Remove the supply roll bar:
•
Facing the right side of the plotter, grasp the right end of the bar
and shift it toward the right. This depresses the spring-loaded
hub at the far end of the plotter and frees the near end from the
drive hub.
•
Lift the bar away from the plotter and lay it on the floor.
3. Using a ¼-inch hex wrench, loosen the screw on the holding clamp,
then pull the plastic end-plate from the far end of the supply roll bar.
If you are replacing an empty supply roll, pull the cardboard tube off
the supply roll bar. You can use this cardboard tube as your new
take-up roll. Refer to the procedure on page 5-7.
4. Lay the new supply roll on the floor beside the plotter, positioned so
the paper feeds counterclockwise when viewed from the operator
control panel. Remove the plastic inserts from both ends of the
cardboard spool.
End Plate
Supply Roll Bar
Clamp
