Gerber P2C™ 600
User's Manual
Operation
2-6
An asterisk (
!
) will appear to indicate that the new pouncing pressure has
been set.
2.2.7
USER CONFIGURATION (“USER CONFIG”)
Each of the four user configurations represents a series of submenus that allow
the user to configure the cutter's operating parameters. NOTE: Access to some
of the submenus will be determined by the plotting language being used.
The four user configuration (“USER CONFIG 1”, “USER CONFIG 2”, etc.) menus
are maintained independently.
!
To select a different user configuration, proceed as follows:
1.
Power on the cutter.
2.
Press the
key.
3.
Press the
key until USER CONFIG is displayed.
4.
After pressing
, press the
or
jogging key until the desired
user configuration number is displayed.
NOTE
Before altering any of the items in the USER CONFIG menu, make sure
that you have previously selected the right configuration number in
the USER CONFIG (1-4) menu.
Figures 2-2 and 2-3 show the USER CONFIG menu parameters.
