Using the Engraver Option
15
6.
Move the engraver spindle to the start position over the material, then put
the initialization gage on the material under the spindle.
7.
Press the Z axis down arrow key on the control pad so that the nose cone
just touches the gage.
8.
Install the cutter as described on page 13.
9.
Press MATL INIT on the control pad. The display reads:
MATERIAL INIT
1/2
Init from material
A: Initialize
10. Press A to initialize the spindle.
11. Remove the gage.
12. Press ADJ DEPTH on the control pad. The display reads:
ADJUST DEPTH
0.000 in
A: Increase
B: Decrease
13. Press A until the display reads 0.100 inches then press ENTER on the
control pad. This increases the depth slightly so that the spindle spring
slightly compresses and holds the nose cone firmly on the material surface.
14. Press EXIT on the control pad until you get to the Status menu.
Setting the cutting depth
The micrometer establishes the cutting depth in the float mode. The cutting
depth must be set to the same total depth specified in the ART Path file.
On engravers equipped with the english spindle, the micrometer dial is divided
into increments of .001". The dial is labeled with numbers every .005". One
complete revolution of the dial is .025".
Summary of Contents for Sabre Engraver Option
