E-6
E-7
Always unplug the unit before servicing it in any way.
•
The water temperature of the water remaining in the unit after use may be high.
•
Do not submerse the unit in the water, or allow water to enter the inside of the unit.
•
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the blast port. Wash
out the unit with fresh water using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft, damp cloth if needed.
WATER TANK
If water spots remain in the water tank, wipe the inside down with a soft cloth.
Do NOT use soap or detergents.
ULTRASONIC DISK
Remove the tank (Fig. 1) and use the enclosed cleaning brush to regularly remove
build up and deposits from the disk area (Fig. 2).
**Diluted white vinegar will help to prevent this build up.
(Fig. 1)
(Fig. 2)
Clean and fully dry the inside and outside of the unit before storing it.
•
DO NOT leave water in the unit.
•
Store in a cool, dry place.
•
*Clean the disk with the
brush only. No other
cleaning tool should
be used. BRUSH ONLY.
(Fig. 2)
6.
Power Button
Before turning on make sure
there is water in the unit. Press
the POWER button.
7.
Cool or Warm
Humidification Button
Press to select cool or warm mist.
Water temperature is maintained
at room temperature for cool
setting and 80 degrees for warm.
8.
Spray Control Button
When you press the Spray Control
button there are three options:
Press once for LOW
Press twice for MEDIUM
Press three times for HIGH
*Lights get higher as spray increases.
9.
Night
Light
Feature
Press the Night Lamp button at
the top of the unit to illuminate
the night light feature.
10.
Water Refill Button
When the Water Refill button lights
up it is time to refill the water tank.
11.
Humidity Spout Direction
Broaden mist in two different
directions throughout the room.
Ultrasonic Disk
