German pool PRO-9S, User Manual

Notice for Operation

P.9

-   Insert the measuring cup to the lid (align the arrow on the cup to the       symbol on the lid and turn it to    

     position). Then press down the lid to the blender jar to close. To open, pull up by the flap  f the lid.

-  During operation, close the lid tightly to avoid injuries due to spilling or splashing of hot liquids.

-  Wind part of the power cord underneath the unit base. Prevent rubber foot from stepping on the power cord.

- When the food is too thick or there is too little liquid in the jar, the motor will be dragged to a low speed or stop 

to operate. Hence, when blending thick and sticky food, start blending from low to high speed. If it is still unable 

to blend, disconnect the power and stir the food inside the jar using a rubber stirrer to drive out the air trapped 

in food. Then close the lid and switch on the blender to continue the operation.

-   When overheating is sensed, the temperature monitoring system will be activated and would stop the operation 

of the motor. In this case, put the appliance in a place with good ventilation to cool it down for 45 minutes. The 

system will be reset and you may resume the operation of the appliance.

- Keep hands and utensils out of the container while the motor is running to prevent the possibility of severe 

personal injury and/or damage.

- In making hot beverage or soup (such as soy milk, porridge, bisque, etc.), please ensure that the lid is secured 

tightly to the jar to prevent it from falling.  Please be advised to start the operation at low speed fi st and then 

gradually increase the speed, or simply use the “Pulse” mode.

- When making sauces (eg. almond sauce, jam and sesame sauce), stuffing and nuts, p t in between 2 and 3 

cups of ingredients. The amount should neither be too large or too little. Keep the blending time below 2 min to 

prevent any burnt smell due to overheating. Too much ingredients may lead to overloading and overheating of 

the motor. In this case, wait till the motor temperature falls before operating again.

- Please put liquid and soft food into the jar before putting in hard food or ice cubes.

- When the operation finish s, please wait until the blade assembly comes to a complete stop before taking up

the blender jar.

-  If you feel a burnt smell from the blender, stop the operation immediately.  It may be caused by the abrasion at 

the rubber cushion base if it is not properly assembled.

- Do not operate continuously for over 10 minutes each time.