German pool PRO-P10, User Manual

Care & Maintenance

P.10

-  Power plug must be disconnected before cleaning and repair.

-  Clean surface of the blender jar with a soft cloth or sponge. The measuring cup and the seal ring can  

   be detached for cleaning.

-  The blender jar can be rinsed with water. 

-  The seal ring is detachable from the lid for easy cleaning.

-  After cleaning, put the blender jar on its the side or upside down (Note 1) to dry*. Do not immerse    

   the whole jar in water.

-  Do not immerse the unit base or power cord into water or other liquids. Clean the unit base by soft cloth.

Specifications are subject to change without prior notice.

If there is any inconsistency or ambiguity between the English version and the Chinese version, the Chinese version shall prevail. 
Refer to www.germanpool.com for the most up-to-date version of the Operating Instructions.

Model No

PRO-V10 Limited Edition

Voltage / Frequency

220-240 V ~ 50-60 Hz

Rated Power

1,680 W

Dimensions

           (H)  540 mm

           (W) 220 mm

           (D)  220 mm

Technical Specifications

*

To dry the blender jar in upside down position, remove the residual water with a dry cloth. Do not position near the sink or basin to avoid water spraying 

to the bottom part of the jar. This may cause rusting of the bearing and thus affect the performance of the blender.

A Friendly Reminder : 

To effectively remove dirt on the jar and blades and help them last longer, do the following: add in water 

and lemon, close the lid and then press “Pulse ” button for 2 to 3 times. Replace liquid with clean water 

and repeat the above step.