P.40
P.41
Using the freezer compartment
Temperature programming and control:
different temperatures can be selected, as indicated by the 3
green leds (S2-S3-S4). To change settings, press button (T1); on each click the illuminated led turns off
and the next one flashes for 4 seconds according to the sequence S2-S3-S4 - S5. The new setting is saved
at the end of the flashing phase. Activation of SUPER mode (S5) is by means of button (T1) after which the
yellow led (S5) is permanently lit.
The programmed functions are memorised also in the event of a power failure or when the appliance is
disconnected.
Note:
•
The distance between the shelves and the rear internal wall of the refrigerator ensures that air
circulates freely.
•
Do not place food in direct contact with the rear wall of the refrigerator compartment.
•
Do not place food that is still warm into the compartments.
•
Keep all liquids in closed containers.
The NO-FROST system guarantees a constant temperature and a more rapid freezing capacity. The
humidity-free, forced air circulation tends to dry food up quickly and for this reason we advise keeping all
food in closed containers.
Using the freezer compartment
Freezer compartment is started up automatically
After start-up the freezer compartment takes approximately three hours to reach the required tempera-
ture for storing frozen food.
SUPER mode
Super mode is activated by pressing button (T1) repeatedly until the yellow led S5 illuminates.
SUPER mode stops automatically after approx. 27 hours, but it can be interrupted at any time by press-
ing T1 as many times as required for the new setting. During SUPER mode, the compressor runs for 65
minutes ON and 25 minutes OFF.
Temperature alarm
The alarm is activated when the internal temperature of the freezer compartment exceeds -12
℃
(for
example -11
℃
). On activation, the red led (S6) flashes.
Possible causes:
•
An excessive amount of food has been placed in the freezer (see freezing methods).
•
The door has been left open.
•
There has been a power cut.
•
There is a fault in the appliance.
