8
INSTALLATION
•
Safety first:
Before installing your new bar fridge, read all safety instructions in
this manual, especially the sections on electrical safety and installation.
• Do not tilt the appliance more than 45º from upright when moving.
• This appliance is designed to be freestanding only and is not be recessed
or built in.
• Do not apply force to any part such as the condenser or door.
• Place the bar fridge on a strong, level floor that is solid enough to support the
unit when it is fully loaded.
• To fix the balance, Adjust the levelling legs at the bottom of the appliance.
• Ensure there is nothing that could prevent the door from closing.
•
SPACING:
Allow 10cm clear space between the back and 10cm on the sides of
the appliance and your wall or anything else to make sure there is enough air
circulation, which is needed to allow for the cooling of the compressor
and condenser.
• If you have to position the refrigerator on carpet, use a plastic carpet protector
underneath the appliance.
BE SURE TO PLACE APPLIANCE:
• Away from direct sunlight.
• Away from sources of heat (may increase power consumption).
• An area without excessive moisture and high humidity.
WARNING:
Before you plug in the appliance, let it stand upright for 2 hours.
This will allow the refrigerant gases to settle into the compressor and reduce the
possibility of a malfunction in the cooling system from transportation.
10cm
5cm
5cm
10cm
Back
Top
SIDE VIEW
TOP VIEW
30cm
