DAN0808
16
DESCRIPTION (fig. A)
Your hammer drill has been designed for drilling in concrete, stone, wood and steel and for light chipping and
chiseling applications.
1 on/off switch
2 Switch hammer function
3 Switch chisel function
4 Chuck
5 Collar
6 Depth stop
7 Side handle
8 Cover lubrication point
9 Carbon brush holder
Mounting and removing a bit or chisel (fig. A)
This tool uses drill bits and chisels with a special tool holder system for quick and easy mounting.
Apply a small amount of grease on the bit or chisel shaft.
Pull the collar (5) backward and insert the shaft of the bit or chisel into the drill chuck (4). Turn the bit or
chisel into the shaft is locked in the drill chuck.
Release the collar (5).
In order to remove the bit or chisel, pull the collar (5) backward and remove the bit or chisel from the drill
chuck.
Before mounting or removing a bit or chisel, first remove the mains plug from the socket.
Using the separate chuck (fig. C)
With the separate chuck your machine is suitable for standard drill bits.
Select the drill without hammering function.
Insert the adaptor (11) in the drill chuck (4).
Fasten the separate chuck (12) on the screw-thread. Tighten securely but do not force.
In order to remove the chuck, proceed in the reverse order.
Use the separate chuck for drilling without hammering exclusively.
If you use the chuck in another function it will be damaged.
For inserting a drill bit in the separate chuck proceed as follows:
Open the chuck (12)
Insert the drill into the chuck.
Fasten the chuck by hand.
Fasten the chuck firmly by inserting the chuck key in one of the holes in the side of the chuck and turning
it clockwise.
In order to remove a drill, proceed in reserve order.
Before inserting or removing a drill, always pull the plug from the wall socket.
Summary of Contents for DAN0808
Page 2: ...DAN0808 2 ...
Page 20: ...DAN0808 20 ...