Remote Maintenance by telnet
67
2
Note
❒
To get the above addresses, contact your network administrator.
❒
Use the default configuration if you cannot obtain setting addresses.
❒
The IP address, subnet mask and broadcast address are the same as that for
the ethernet interface and IEEE 802.11b interface.
❒
TCP/IP configuration is the same for both Ethernet and IEEE 802.11 interface.
If interfaces are changed, the new interface inherits the configuration.
❒
Use “0x” as the initial two letters of a hexadecimal address.
info
Use the “info” command to display printer information such as paper tray, out-
put tray, and printer language.
❖
Printer information display
msh> info
Reference
p.87 “Getting Printer Information over the Network”
ipp
Use the “ipp” command to view and configure IPP settings.
❖
Viewing settings
The following command displays the current IPP settings:
msh> ipp
❖
IPP timeout configuration
Specify how many seconds the computer waits before canceling an interrupt-
ed print job. The time can be entered between 30 to 65535 seconds.
msh> ipp timeout [30 - 65535]
❖
IPP user authorization configuration
Use IPP user authorization to restrict users to print with IPP. The default is
“off”.
msh> ipp auth {basic|digest|off}
• User authorization settings are “basic” and “digest”.
• If user authorization is specified, register a user name. You can register up
to 10 users.
