Monitoring and Configuring the Printer
84
2
wins
Use the “wins” command to configure WINS server settings.
❖
Viewing settings
msh> wins
• If the IP address obtained from DHCP differs from the WINS IP address,
the DHCP address is the valid address.
❖
Configuration
msh> wins “interface_name” {on | off}
• {on} means “active” and {off} means “inactive”.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface is installed.
❖
Address configuration
Use the following command to configure a WINS server IP address:
msh> wins “interface_name” {primary|secondary} “IP ad-
dress”
• Use the “primary” command to configure a primary WINS server IP address.
• Use the “secondary” command to configure a secondary WINS server IP
address.
• Do not use “255.255.255.255” as the IP address.
rate [auto|11m|5.5m|2m|1m]
You can set the IEEE 802.11b transmitting
speed.
The speed you specify here is the speed at
which data is sent. You can receive data at
any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m:2 Mbps fixed
1m: 1 Mbps fixed
Interface name
Interface configured
ether
Ethernet interface
wlan
IEEE 802.11b interface
Parameter
Value configured
