Opera on
Opera on
USER MANUAL | EG-6620 Digital Conference System
09
ALL UNIT OFF/ON
All microphone units connected will be
switched on/off.
Note: All units can be ac ve when the system
set to “ALL ON MODE”.
CERTAIN UNIT ADDRESS
To allow user to allocate a specific ID to a microphone unit.
For example: A system consisted 30 mics, when an extra microphone to be included into
the system, then user can define this mic’s ID as 31 separately.
Note: Should only 1 microphone unit connected to the controller on this opera on.
Other microphone units should be disconnected during this opera on.
ALL UNIT ADDRESS
To configure the ID of all microphone units connected to the system. User can input the
ini al ID, and ID will be set in ascending order to each microphone unit ll all units assigned,
then reboot the controller a er the opera on.
Conference control – Volume
LINE IN / OUT
To adjust the audio level of input / output.
SOUND CONTROL
To adjust sensi vity of voice ac va on
func on.
BUZZER MUTE
To enable or disable the buzzer of the
controller.
UNIT LOUDSPEAKER
To adjust volume of speaker of all microphone
units.
UNIT LOUDSPEAKER MUTE
Speakers on the units will be muted when this
is on.
CERTAIN UNIT OFF/ON
To switch on/off specific microphone unit by
input its ID.
USER MANUAL | EG-6620 Digital Conference System
08
AUTO OFF
To switch off the microphone when no voice
signal pickup in set me frame. 0 S means
this setup is disable.
TIME OFF
To set the me frame for the microphone unit
in ac ve, the unit will be switched off when
the me set is up.
Conference control – Chairman setup
MANUAL RECOVER
Delegate units will be switched off when
priority key is pressed, delegate unit can
open by pressing the ON key again.
AUTO RECOVER
Delegate units will be muted if priority key
keeps being pressed, the delegate unit will
unmuted when priority key released.
Conference control – Control unit
