18
PROBLEM
ACTION
The lift continues to raise or descend after the hand
control button is released.
Activate the red emergency Stop button and pull the
battery out - remove the patient from the lift and contact
qualified personnel.
The lift does not raise or descend when the hand control
button is pressed.
•
Make sure that the battery is fully engaged in the
battery compartment.
•
Make sure that the hand control connection plug is
properly engaged in the socket.
•
Make sure that the battery is charged.
•
Use the emergency lowering to descend the
patient, see
Emergency High/Low on page 12
.
Contact qualified personnel as soon as the patient
is removed from the lift.
The lift is hard to manoeuvre during the transfer.
•
Make sure all brakes are released.
•
Make sure all castors role and swivel freely.
•
If the problem persists, remove the patient from
the lift and contact qualified personnel.
The lift is making abnormal sounds during lifting or
transfer.
Remove the patient from the lift and contact qualified
personnel.
The lift beeps shortly once every minute when not
operated.
Contact qualified personnel.
It is only possible to lower the lift.
The lifting device of this equipment is equipped with a
safety nut. If the safety nut will be activated it will only
be possible to lower the equipment into a safe position.
In case of this scenario stop using the equipment and
contact qualified personnel for repair.
WARNING
To avoid injury, make sure that the patient
is not left unattended at any time.
Troubleshooting
