29
Loading side – manual loading
The above flowchart shows the process of loading a rack at loading side. The numbers are
pop-ups required during this process. The most important aspects are the following: it is
not allowed to load empty racks at this side due to potential efficiency issues if this is done
during a production batch. When manually loading a rack with nests, the timestamp can be
entered through this loading flow. Finally, if the rack is unchanged compared to when it
was unloaded (and indicated by the operator as being unchanged), only non-processed can
be loaded at this side. This is for efficiency reasons.
Unloading side – manual loading
Here, empty racks can be entered. If the unloading side is not empty, the system checks if
it is being processed. If this is not the case, the operator should load it at the loading side of
the autoclave. If there is no pharma-alarm on the rack, the system will continue unloading
without additional input. However, if there is a pharma-alarm, the supervisor should use
his clearance to decide that this rack should be pushed through. For this, the flag
“automatic unloading authorized” is used as the pharma-flag shouldn’t be set to FALSE
for GMP or manual review.
Rack entered
Pop-up/decision
Confirm that the rack is not
empty
CANCEL
CONFIRMED
MANUALLY
FILLED
UNCHANGED
Rack ID
- Data stored
RACK
Empty racks should be loaded
at unloading side, remove rack
-> NOT ALLOWED ->
alarm
that triggers a pop-up(2)(C3)
Confirmation & Request to enter
manual timestamp. (4)
Rack Status:
non-processed
Empty flag:
false
Timestamp entered:
-
Update hold timestamp
-
Hold time type: manual
Check on process status:
ONLY non-processed is OK
-> Alarm that triggers a
pop-up (5)
Confir all data is re-entered
into the shift register
Summary of Contents for GEV TS 121650 AR-2
Page 1: ...1 GEV TS 121650 AR 2 PFIZER ROBOTIC SYSTEMS 0011393179 010 USER MANUAL...
Page 49: ...49 Robot pendant Manual Auto mode Auto Manual mode Quick menu Key selector...
Page 52: ...52 Quick select Jogging Increments Motion mode Step mode...
Page 54: ...54 Robot 210 Home position Robot 220 Home position...
