10
- Function No. 2: RAPID TEST.
With this function it is possible to check the correct installation carrying out a test of all the
alarm connections.
Additional modules entry test:
triggering the sensor (ultrasonic microwaves, inclination
etc.) the system generates 1 beep and No.1 GREEN flash of the del LED on the receptacle.
DOORS pin switch test:
opening one or more doors the system generates 4 beeps
and 4 GREEN flashes of the LED on the receptacle.
BOOT/BONNET switch test:
opening the boot and bonnet the system generates 5 beeps
and 5 GREEN flashes of the LED on the receptacle.
Starting attempt test:
switching the ignition key on the system generates 6 beeps and
6 GREEN flashes of the LED on the receptacle.
Wires cut test:
taking out the power supply to the alarm the system generates 7 beeps
and 7 GREEN flashes of the LED on the receptacle.
There are two ways to come out from the RAPID TEST:
1 - Automatically waiting 2 minutes without triggering any alarm line.
2 - Place the electronic key incorporated in the handset to the RECEPTACLE/LED or press
the “ON/OFF” handset button.
- Function No. 3: COMFORT CLOSING.
If enbled it allows the windows to automaticaly close (only for the vehicles equipped with
this function) supplying a closing command with a duration of 40 seconds after 5 seconds
from the doors closing and the alarm is set.
1 - Select the function and ENABLE/DISABLE pressing the “ON/OFF” handset button.
- Function No. 4: ACOUSTIC SIGNAL WHEN ARMING/DISARMING.
It is possible to program the acoustic signal (beep) to indicate the alarm arming and
disarming on or off.
1 - Select the function and ENABLE/DISABLE pressing the “ON/OFF” handset button.
- Function No. 5: INDICATOR COMMAND.
If the function is
ENABLED
with the only ORANGE wire it is possible to command the
indicators by the emergency indicators original switch (only on the vehicles equipped with
this function).
1 - Select the function and ENABLE/DISABLE pressing the “ON/OFF” handset button.
- Function No. 6: DOOR SWITCH PULSING MANAGEMENT.
If this function is ENABLED it allows connection to vehicles with negative impulses (pulsing)
on the original doors contacts.
1 - Select the function and ENABLE/DISABLE pressing the “ON/OFF” handset button.
- Function No. 7: POSITIVE DOOR SWITCH MANAGEMENT.
If this function is ENABLED, it allows connection to the door contacts which supply a
stable positive when the door is opened.
