Gevi GECME418E-U, Instruction Manual

—1.Always use clean, room temperature water in the coffee maker. 
—2.For an optimum coffee taste,  buy whole coffee beans and finely 
grind them just before brewing.
—3.Grind the bean every time before brew espresso in case you ever 
used coffee powder.  You must keep the unused coffee powder in a 
cool, dry place.  
—4. Do not reuse coffee powder since this will greatly reduce the
 coffee’s flavor. Reheating coffee is not recommended as coffee is 
at its peak flavor immediately after brewing. 

The coffee maker 

cannot work.

All four lights are 

blink blue light at 

the same time.

/

The power outlet is 

not plugged well.

There is not enough 

water in the water 

tank ⓭.

Plug the power cord 

into a wall outlet co-

rrectly, if  the applia-

nce still does not work, 

please contact with 

the authorized service

facility for repairing.

Please fill up the water 

into the water tank ⓭, 

but pay attention that 

the water to fill must 

not to exceed the MAX 

line.

Solution

Problem

Picture

Possible Cause

34

33

• Repeat the Steps from 1-3 for three times then the descaling is 
finished.

•  The  Descaling  Cycle  is  complete.  The  machine  will  return  to  the 
READY state.

Descaling Cycle Clean Up

1. Empty water from the containers and clean, ensuring that all traces 
of the descaling solution have been removed.

/

The power button ❶ 

keep blue light fixed, 

the other button’s 

light ( single cup bu-

tton ❷,  double cup 

button ❸ and steam 

button ❹)blink blue 

and beep at the same 

time.

Coffee leaks out 

from outer side of 

portafilter ❿.

The machine is on 

while the steam/water

knob ⓮ is not fixed 

in the off position.

1.There is some coffee 

powder on the edge of 

portafilter ❿.

2. The portafilter ❿ is 

not installed properly.

3. The coffee powder 

is too fine.

4. The coffee powder 

on the portafilter ❿ 

is pressed too tightly.

Reset  steam / water 

knob ⓮ to  horizontal 

position (off-position).

Clean coffee powder 

on the edge of the 

portafilter ❿.

Re-install the porta-

filter ❿ correctly.

Do not use coffee po-

wder that is too fine.

Press the coffee pow-

der lightly to the max 

line.

Solution

Problem

Picture

Possible Cause

Note:After finish that ,  you could pour away the residual citric 

acid mix in the tank and clean the parts ( Water tank  ⓭,Steam 
wand   ⓰ ,  seal ring of the filter holder ❾) before making coffee. 
Refill the tank with water and brew water before making coffee 
again.  

TIPS FOR PERFECT BARISTA

TROUBLESHOOTING