10
Marking
label
Keyguard
Labelling keys
As standard the keys are marked. There are
several labelling suggestions on the enclosed
sheet. Choose a suitable labelling. Remove the
keyguard carefully otherwise the plastic legs may
break. Remove the standard labelling and insert
the marking label according to the figure. Do not
insert the label fully. It must be possible to see the
digits on the top of each symbol when
programming next section.
If you are not satisfied with the enclosed labelling go to
Products/Software/Overlay design/Overlay design Control TV. Download a
Word document with additional symbols. In that document it is possible to
create a personal labelling. There are also symbols for DVD, CD a. s o.
Learning IR codes from another remote control
1.
Place the two transmitters on a table with the original transmitter directed
towards the rear of Control TV. Make sure the batteries in the original remote
control have full capacity. Do not place the transmitters in intense light (e.g.
sunlight) when programming. Also see section above about labelling.
Note! Control TV automatically leaves programming mode after one minute.
2.
Press
P
and key
1
at the same time. Use the enclosed paper clip. The
indicator light flashes red.
3.
Press and release the key on Control TV where, for instance, ”Volume” is to
be programmed. The indicator light
B
now emits a steady orange light.
P
A
B
